HP rp5400 Installation Guide, Third Edition - HP rp5400 Family of Servers - Page 47
Step 13., Release the plunger pins to secure the server.
View all HP rp5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Server Unpacking and Installation Install Stand-Alone Server in a Cabinet Step 13. Use six, M5 x 12 screws (without washers) to attach the tray to the slides. Three screws are used to attach each slide. Insert the screws through the slides, through the tray and tighten into the threaded nuts located on the inside of the sides of the tray. 3 Pan Head M5x12 T25 screws on each side Step 14. From the bottom of the tray pull the plunger pin down and give it a 1/4 turn to hold it in place. Step 15. Position the server on the tray aligning the plunger pins with the alignment holes in the chassis. Step 16. Release the plunger pins to secure the server. Chapter 2 47
Server Unpacking and Installation
Install Stand-Alone Server in a Cabinet
Chapter 2
47
Step 13.
Use six, M5 x 12 screws (without washers) to attach the tray to the slides. Three screws are used to
attach each slide. Insert the screws through the slides, through the tray and tighten into the
threaded nuts located on the inside of the sides of the tray.
Step 14.
From the bottom of the tray pull the plunger pin down and give it a 1/4 turn to hold it in place.
Step 15.
Position the server on the tray aligning the plunger pins with the alignment holes in the chassis.
Step 16.
Release the plunger pins to secure the server.
3 Pan Head
M5x12 T25 screws
on each side