HP rp5400 Installation Guide, Third Edition - HP rp5400 Family of Servers - Page 71

Secure Web Console Installation, Step 1.

Get HP rp5400 PDF manuals and user guides View all HP rp5400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 71 highlights

Cabling and Power-Up Secure Web Console Installation Secure Web Console Installation The following section describes installation of the HP Secure Web Console on inside of the rear door of a rack-mounted rp54xx Server. For technical, installation, and configuration instructions for the Secure Web Console, refer to the following URLs on the Internet: General information: http://www.hp.com/ Documentation: http://www.docs.hp.com NOTE Either the system console (HP series 700 terminal) or the HP Secure Web Console may be installed on an rp54xx Server, but not at the same time. Both console types use the same DB9 type LAN Console connector. Cabinet To install the HP Secure Web Console on an rp54xx Server, refer to the previous figure and the HP Secure Web Console documentation, then proceed as follows: Step 1. Install the wire mounting bracket by carefully inserting the two top prongs through the vent grill in the rear door of the cabinet as shown above. Position the bracket toward the hinge side of the door. Chapter 3 71

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
Cabling and Power-Up
Secure Web Console Installation
Chapter 3
71
Secure Web Console Installation
The following section describes installation of the HP Secure Web Console on inside of the rear door of a
rack-mounted rp54xx Server.
For technical, installation, and configuration instructions for the Secure Web Console, refer to the following
URLs on the Internet:
General information:
Documentation:
NOTE
Either the system console (HP series 700 terminal) or the HP Secure Web Console may be
installed on an rp54xx Server, but not at the same time. Both console types use the same DB9
type LAN
Console
connector.
To install the HP Secure Web Console on an rp54xx Server, refer to the previous figure and the HP Secure
Web Console documentation, then proceed as follows:
Step 1.
Install the wire mounting bracket by carefully inserting the two top prongs through the vent grill in
the rear door of the cabinet as shown above. Position the bracket toward the hinge side of the door.
Cabinet