IBM 79856au User Guide - Page 46
Riser
UPC - 883436004374
View all IBM 79856au manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Riser card The following illustration shows the location of the adapter expansion slots on the riser card. Note: For clarity, the riser-card assembly is inverted in the illustrations. HTX adapter connector Riser card assembly Remote Slimline Adapter II connector To install an adapter, complete the following steps: 1. Read the safety information that begins on page v and "Installation guidelines" on page 23. 2. Turn off the server and peripheral devices and disconnect all power cords and external cables (see "Turning off the server" on page 13). 3. Determine which expansion slot you will use for the adapter. 4. If you are installing an adapter in slot 1, remove the riser-card assembly (see "Removing the riser-card assembly" on page 26). 5. Slide the expansion-slot cover out of the PCI low-profile expansion slot or the riser-card assembly expansion slot. 6. Install the adapter. The following illustration shows how to install an adapter in the riser-card assembly. Note: For clarity, the riser-card assembly is shown inverted in the following illustration. HTX adapter HTX riser card Riser card assembly Remote Supervisor Adapter II SlimLine 7. If you removed the riser-card assembly to install the adapter, align the riser-card assembly with the release-tab posts, rear guides, and connector; then, press the riser-card assembly firmly into the connector (see "Installing the riser-card assembly" on page 28). 32 System x3655 Type 7985: User's Guide