IBM 79856au User Guide - Page 71
Installing, hot-swap, power, supply
UPC - 883436004374
View all IBM 79856au manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Important: If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly inserted; open the retaining clips, remove the DIMM, and then reinsert it. 9. Replace the riser-card assembly (see "Installing the riser-card assembly" on page 28). If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on page 61. Installing a hot-swap power supply The server supports a maximum of two hot-swap power supplies. Important: Only the configurations shown in the following table are supported: Installed power supplies Power supply 1 Power supplies 1 and 2 Required fans Fans in locations 3, 4, 8, 9, and 10 All 10 fans Statement 8: CAUTION: Never remove the cover on a power supply or any part that has the following label attached. Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician. Chapter 2. Installing optional devices 57