IBM 79856au User Guide - Page 74
Removing, fan-bracket, assembly
UPC - 883436004374
View all IBM 79856au manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Attention: To ensure proper server operation, if a fan fails, replace it as soon as possible. Hot-swap fan To install any of the 10 replaceable fans, complete the following steps: 1. Read the safety information that begins on page v and "Installation guidelines" on page 23. 2. If you have not done so already, slide the server out of the rack and remove the cover (see "Removing the cover" on page 26). Attention: To ensure proper system cooling, do not remove the top cover for more than 2 minutes during this procedure. 3. Orient the new fan over its position in the fan assembly bracket so that the LED on top of the fan is toward the left side of the server. 4. Push the new fan into the fan assembly bracket until it clicks into place. 5. Repeat steps 3 and 4 until all the new fans are installed. 6. Replace the cover and slide the server into the rack. Removing the fan-bracket assembly To remove the fan-bracket assembly, complete the following steps: Fan bracket release latches Fan bracket 60 System x3655 Type 7985: User's Guide