Intermec PD41 PD41 and PD42 Commercial Printer User's Manual - Page 101
Setup, Print Defs, LSS Test, LSS Auto., For gap or slot detection, For black mark detection
View all Intermec PD41 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Chapter 4 - Troubleshooting and Maintaining the Printer 3 Make sure that there is a label, not a gap or black mark, at the sensor. 4 Make sure that the media runs as close to the center of the printer as the guides will allow. 5 Press Setup ( ). 6 Go to Print Defs > LSS Test > LSS Auto. The cursor will in the center of the screen as shown below. LSS AUTO 7 For gap or slot detection: Lift the printhead and slowly pull out the media in the media feed direction. When the label stop sensor detects a gap or a detection slot, the cursor moves to the right. LSS AUTO 8 For black mark detection: Lift the printhead and slowly pull out the media in the feed direction. When the label stop sensor detects a black mark, the cursor moves to the left. LSS AUTO If the cursor behaves as described in Steps 7 and 8, the label stop sensor is working and is properly aligned. PD41 and PD42 Commercial Printer User's Manual 87