Intermec PD41 PD41 and PD42 Commercial Printer User's Manual - Page 45
To con the printer to use WPA or WPA2 Enterprise mode, can be OFF, LEAP, TTLS, or EAP-FAST. - password
View all Intermec PD41 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Chapter 2 - Connecting the Printer To configure the printer to use WPA or WPA2 Enterprise mode 1 Send the following commands to login as an admin and set the SSID: .x,su -p pass admin ws,SSID,xxxxx where xxxxx can be from 0 to 32 alphanumeric characters. Note: The default password for logging in as an admin is "pass." If you have changed the password, you will need to use your password instead of "pass." 2 Send one of the following commands to enable WPA-802.1x or WPA2-802.1x authentication. You should also send the WPA_PSK command that does not contain a value: ws,WPA,ON ws,WPA2,ON ws,WPA_PSK, 3 Send these commands to configure the EAP_TYPE: ws,EAP_TYPE,xxxx where xxxx can be OFF, LEAP, PEAP, TTLS, or EAP-FAST. ws,.EAP_USER,xxxx ws,.EAP_PASS,xxxx where xxxx is the unique username and the unique password for this protocol. 4 If you are using EAP-FAST, you can use PAC and ACQUIRE_PAC commands. The PAC setting specifies the PAC file to use for EAPFAST authentication. The ACQUIRE_PAC setting checks to see if automatic PAC file provisioning is enabled. You can set ACQUIRE_PAC to on or off. • Send the following command to set PAC to use /tmp/my.pac with a pass phrase of "verysecret": ws,PAC,/tmp/my.pac @verysecret • Send the following command to set ACQUIRE_PAC to on: ws,ACQUIRE_PAC,ON PD41 and PD42 Commercial Printer User's Manual 31