Intermec PD41 PD41 and PD42 Commercial Printer User's Manual - Page 95
Adjusting Printhead Pressure, Adjusting, Printhead Balance.
View all Intermec PD41 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Chapter 4 - Troubleshooting and Maintaining the Printer Adjusting Printhead Pressure The pressure of the thermal printhead against the platen roller is adjusted at the factory. You may need to readjust the printhead pressure if the printing is weaker on one side of the media, or if the thermal transfer ribbon starts to crease (indicated by unprinted white streaks along the media feed direction). Note: Before adjusting the printhead pressure, try to move the outer balance box as described in the the previous procedure, "Adjusting Printhead Balance." To adjust the printhead pressure 1 If you have installed thermal transfer ribbon, remove it. 2 Pull out on the printhead lever and turn it counterclockwise to lift the printhead. PD41 and PD42 Commercial Printer User's Manual 81