JVC DLA-HX1U Instruction Manual - Page 20
Allowable input signals, Signal, Horizontal resolution, Hor Pixels, Vertical resolution, Ver Lines
View all JVC DLA-HX1U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Connecting to Various Devices Ⅵ Allowable input signals Signal PC system PC98 PC/AT DOS/V DVI* Mac Video DVI* (HDCP) VESA350 PC98 VGA 60 Hz* VGA 72 Hz VGA 75 Hz VGA 85 Hz SVGA 56 Hz SVGA 60 Hz* SVGA 72 Hz SVGA 75 Hz SVGA 85 Hz XGA 43 Hz XGA 60 Hz* XGA 70 Hz XGA 75 Hz XGA 85 Hz SXGA 43 Hz SXGA 60 Hz* SXGA 75 Hz SXGA 85 Hz SXGA+60 Hz* MAC13 MAC16 MAC19 MAC21 HDTV (1035i) 60 Hz HDTV (1035i) 59 Hz 480p* 720p 60 Hz* 720p 59 Hz* 1080i 60 Hz* 1080i 59 Hz* 1080i 50 Hz 1080 30SF/30P 1080 25SF/25P 1080 24SF/24P NTSC PAL SECAM VIDEO system Horizontal resolution Hor (Pixels) 640 640 640 640 640 640 800 800 800 800 800 1024 1024 1024 1024 1024 1280 1280 1280 1280 1400 640 832 1024 1152 720 1280 1280 1920 1920 1920 1920 1920 1920 Vertical resolution Horizontal frequency Vertical frequency Ver (Lines) H (kHz) V (Hz) 350 400 480 480 480 480 600 600 600 600 600 768/2 768 768 768 768 1024/2 1024 1024 1024 1050 480 624 768 870 483 720 720 1080/2 1080/2 1080/2 1080 1080 1080 37.86 24.83 31.47 37.86 37.50 43.27 35.16 37.88 48.08 46.88 53.67 35.52 48.36 56.48 60.02 68.68 46.43 63.98 79.98 91.15 64.02 35.00 49.73 60.24 68.68 33.75 33.72 31.47 45.00 44.96 33.75 33.72 28.25 33.750 28.125 27.000 15.734 15.625 15.625 84.13 56.42 59.94 72.81 75.00 85.01 56.25 60.32 72.19 75.00 85.06 43.48 60.00 70.07 75.03 85.00 43.44 60.02 75.03 85.02 60.00 66.67 74.55 74.93 75.06 60.00 59.94 59.94 60.00 59.94 60.00 59.94 50 60/30 50/25 48/24 60 50 50 • The resolutions for the input signals are listed in the table above. • Certain types of signals in the frequency range may not be displayed normally. • When a signal other than those listed above is input, the image could be partially erased or unwanted folds-over the image may appear. • Some signals other than those listed above can be displayed. However, they may require adjustment. • Some of the signals listed above may require adjustment depending on the video board used. • Composite sync (Cs) and G on Sync signals cannot sometimes be handled depending on the devices connected. • VGA signals from the PC could at times be displayed in the video 480p mode. (In this case, the projector enters the video menu when the [MENU] button is pressed.) • The motion picture may be distorted when projecting motion picture from computer. • The image of [DVI-D] input terminal might not be displayed due to HDCP specification change. 20