Lexmark X864 SCS/TNe Emulation User's Guide - Page 66

Option Device # Name Keep Alive Type Keep Alive Time MSGQ # Name MSGQ # Lib IR # Reply Default Value [undefined] None 45 seconds QSYSOPR *LIBL Normal Recommended Value Comments Your device name The host will autoconfigure a device and writer with this (up to 10 characters) name if it does not exist. None or own preference Leave this at the factory default if the host is configured to send a keep alive signal. Choose a different setting to have the SCS/TNe Emulation send a keep alive signal. Your own preference This setting is not used if the Keep Alive Type option (1-3200 seconds) value is set to None (= disabled). If you have chosen to enable a Keep Alive Type set this value to a value smaller than the INACTTIMO defined on the host. Your preferred queue name (up to 10 characters) Specifies the message queue name to which IR replies are reported. This name must already exist on the host. It will not be auto configured. Contact your system administrator if you do not know the message queue name. The library name of Specifies the library of the message queue name set with the message queue the MSGQ # Name option. This library must already exist (up to 10 characters) on the host It will not be auto configured. Contact your system administrator if you do not know the library name. Normal Leave this option at its default value to have printer intervention required conditions reported to the host. AS/400 and iSeries Installation Setup: Task 4 - Configuring the SCS/TNe Emulation 68