Maytag MEDZ600TB Use and Care Guide - Page 14
B. Neutral ground
UPC - 883049064925
View all Maytag MEDZ600TB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
3-wire connection: Power supply cord Use where local codes permit connecting cabinet-ground conductor to neutral wire. A o, C GF A. 3-wire receptacle tNEMA type lO-30R) B. 3-wire plug C. Neutral prong D. Spade terminals with LIp turned ellds E. _" ( 1.9 cm) UZ liste,d strain r_'lief f. Ring terminab G. Neutral (white" or center wire') 1. I.oosen or remove center silver-colored terminal block screw. 2. Connect neutral wire (white or center wire) of power supply cord to the center, silvercolored terminal screw of the terminal block. Tighten screw. 3. Connect the other wires to outer terminal block screws. Tighten screws. !! !I 4. Tighten strain relief screws. 5. Insert tab of terminal block cover into slot of dryer rear paneh Secure cover with hold- down screw. 6. You have completed your electrical connection. Now go to "Venting Requirements." 3-wire connection: Direct wire Use where local codes permit connecting cabinet-ground conductor to neutral wire. ]Direct wire cable must have 5 ft (1.52 rn) of extra length so dryer can be moved if needed. Strip 3_/2" (8.9 cm) of outer covering from end of cable. Strip insulation back 1" (2.5 cm). If using 3-wire cable with ground wire, cut bare wire even with outer covering. Shape ends of wires into a hook shape. E A. Exte'rnal ground conductor screw B. Neutral ground vvir_" C. Ce'nter silver-colore'd t_'rminal block screw D. Neutral wire' (white' or center wire') E. _" ( 1.9 cm) UZ listed strain reli_'f t_.9cm_ When connecting to the terminal block, place the hooked end of the wire under the screw of the terminal block (hook facing right), squeeze hooked end together and tighten screw, as shown. 1. loosen or remove center silver-colored terminal block screw. 14