Nokia N86 8MP Nokia N86 8MP User Guide in US English - Page 139
Slide handling settings, Sensor settings and display rotation, Security settings, Phone and SIM
View all Nokia N86 8MP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Settings Slide handling settings Security settings Select Menu > Tools > Settings and General > Phone and SIM Slide handling. Select Menu > Tools > Settings and General > Select from the following: Security > Phone and SIM card and from the ● Opening the slide - Set the device to answer an following: incoming call when you open the slide. ● PIN code request - When active, the code is ● Closing the slide - Set the device to end an active requested each time the device is switched on. call when you close the slide. Deactivating the PIN code request may not be ● Keyguard activation - Set the device to lock the allowed by some SIM cards. keypad when you close the slide. ● PIN code, PIN2 code, and Lock code - You can change the PIN code, PIN2 code, and lock code. Sensor settings and display These codes can only include the numbers from 0 to rotation 9. When you activate the sensors in your device, you can control certain functions by turning the device. Select Menu > Tools > Settingsand General > Sensor settings. If you forget the PIN or the PIN2 code, contact your service provider. If you forget the lock code, contact a Nokia Care point or your service provider. Avoid using access codes similar to the emergency numbers to prevent accidental dialling of the Select from the following: emergency number. ● Sensors - Activate the sensors. ● Turning control - Select Silencing calls and Snoozing alarms to mute calls and snooze alarms by turning your device so that the display faces down. ● Keypad autolock period - Select whether the keypad is locked when your device has been idle for a certain period of time. ● Phone autolock period - To avoid unauthorised use, you can set a time-out after which the device automatically locks. A locked device cannot be used until the correct lock code is entered. To turn off the autolock period, select None. 139