Home » Panasonic Manuals » Cordless Phones » Panasonic KX-FPG391 » Manual Viewer

Panasonic KX-FPG391 Plain Paper Fax - Page 117

General Information, CAUTION, FCC RF Exposure Warning

UPC - 037988809707

View all Panasonic KX-FPG391 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 117 highlights

CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Some cordless telephones operate at frequencies that may cause interference to nearby TVs and VCRs. To minimize or prevent such interference, the base of the cordless telephone should not be placed near or on top of a TV or VCR. If interference is experienced, move the cordless telephone further away from the TV or VCR. This will often reduce, or eliminate, interference. FCC RF Exposure Warning: This product complies with FCC radiation exposure limits set forth for an uncontrolled environment. To comply with FCC RF exposure requirements the base unit must be installed and operated with its antenna located 20 cm or more between antenna and all person's body (excluding extremities of hands, wrist and feet). The handset unit may be carried and operated with only the specific provided belt-clip. Other non-tested belt-clips or similar body-worn accessories may not comply and must be avoided. The base and handset units must not be co-located or operated in conjunction with any other antenna or transmitter. 12. General Information 115

Section	Page
Location of Controls	2
Location of Controls	2
Location of controls	3
Important Information	5
Safety Instructions	5
Important safety instructions	5
For Best Performance	7
For best performance	7
Expanding Your Phone	8
Expanding your phone	8
Expanding your phone	8
Table of Contents	9
Introduction and Installation	11
Accessories	11
1.2 Accessory information	12
Finding the Controls	12
1.3 Description of base unit buttons	12
1.4 Description of handset buttons	13
1.5 Overview	15
Installation (Base Unit)	16
1.6 Ink film	16
1.7 Paper tray	18
1.8 Recording paper	19
Installation (Handset)	19
1.9 Battery installation	20
1.10 Battery replacement	20
1.11 Belt clip	21
1.12 Headset (optional)	21
Preparation	22
Connections and Setup	22
2.1 Connections	22
2.2 Wall mounting the charger	23
2.3 Battery charge	24
2.4 Selecting the way to use your fax machine	25
2.5 Case 1: TAM/FAX (Telephone Answering Machine/Fax)	26
2.6 Case 2: Distinctive Ring (1 phone line with 2 or more phone numbers)	27
2.7 Case 3: TEL ONLY	28
2.8 Case 4: FAX ONLY	30
Help Button	31
2.9 Base unit help function	31
Volume	31
2.10 Adjusting handset volume	31
2.11 Adjusting base unit volume	32
Initial Programming	33
2.12 Date and time	33
2.13 Your logo	34
2.14 Your fax number	36
Telephone	37
Making and Answering Calls	37
3.1 Making phone calls	37
3.2 Answering phone calls	39
Automatic Dialing	39
3.3 Storing names and telephone numbers into the phone book	40
3.4 Making a phone call using the phone book	41
3.5 Editing a stored item	42
3.6 Erasing a stored item	43
3.7 Copying phone book items	43
Caller ID	45
3.8 Caller ID service	45
3.9 Viewing and calling back using caller information	46
3.10 Caller ID number auto edit feature	48
3.11 Erasing caller information	49
3.12 Storing caller information into the phone book	50
Other Features	51
3.13 Intercom	51
3.14 Transferring a call	51
3.15 Conference	53
3.16 Call share	53
3.17 Room monitor feature	54
Fax	55
Sending Faxes	55
4.1 Sending a fax manually	55
4.2 Documents you can send	56
4.3 Sending a fax using the phone book	57
4.4 Broadcast transmission	57
Receiving Faxes	59
4.5 Receiving a fax manually – Auto answer OFF	59
4.6 Receiving a fax automatically – Auto answer ON	60
4.7 Junk fax prohibitor (preventing fax reception from undesired callers)	62
4.8 Storing undesired callers	62
Distinctive Ring	63
Distinctive Ring	63
5.1 Distinctive Ring service from your phone company	63
5.2 Using two or more phone numbers on a single telephone line	63
5.3 Using three or more phone numbers on a single telephone line	63
5.4 Programming the ring pattern assigned for fax	64
Copy	65
Copying	65
6.1 Making a copy	65
Answering Machine	67
Voice Mailbox	67
7.1 Mailbox features	67
Greeting	68
7.2 Recording your greeting message	68
Incoming Messages	69
7.3 Listening to recorded messages using the base unit	69
7.4 Listening to recorded messages using the handset (Remote operation)	71
Memo Message	72
7.5 Leaving a message for others or yourself	72
Remote Operation	73
7.6 Operating from a remote location	73
Programmable Features	76
Features (Base Unit)	76
8.1 Base unit programming	76
8.2 Basic features	77
8.3 Advanced features	78
8.4 Direct commands for base unit programming features	82
Features (Handset)	84
8.5 Handset programming	84
8.6 Direct commands for handset programming features	90
Option	92
Handset Registration	92
9.1 Canceling the handset registration	92
9.2 Re-registering the handset	92
Help	94
Error Messages	94
10.1 Error messages – Reports	94
10.2 Error messages – Display	94
Troubleshooting	99
10.3 When a function does not work, check here	99
Jams	104
10.4 Recording paper jams	104
10.5 Document jams – sending	107
Cleaning	107
10.6 Document feeder/scanner glass cleaning	107
10.7 Thermal head cleaning	108
Caller IQ Feature	110
Caller IQ Feature	110
11.1 openLCR service for the Caller IQ feature	110
11.2 Activate openLCR services (Need to start up)	110
11.3 Available openLCR services	111
11.4 Turning the Caller IQ OFF / ON	112
General Information	113
Printed Reports	113
12.1 Reference lists and reports (Base unit only)	113
Specifications	114
12.2 Technical data about this product	114
FCC and Other Information	116
12.3 FCC and Other Information	116
Limited Warranty	118
12.4 Limited Warranty	118
Customer Services	120

Match case Limit results 1 per page

12. General Information

115

CAUTION:

Any changes or modifications not expressly

approved by the party responsible for compliance

could void the user

’

s authority to operate this

device.

NOTE:

This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable

protection against harmful interference in a

residential installation. This equipment generates,

uses, and can radiate radio frequency energy

and, if not installed and used in accordance with

the instructions, may cause harmful interference

to radio communications. However, there is no

guarantee that interference will not occur in a

particular installation. If this equipment does

cause harmful interference to radio or television

reception, which can be determined by turning

the equipment off and on, the user is encouraged

to try to correct the interference by one or more of

the following measures:

—

Reorient or relocate the receiving antenna.

—

Increase the separation between the

equipment and receiver.

—

Connect the equipment into an outlet on a

circuit different from that to which the receiver

is connected.

—

Consult the dealer or an experienced radio/TV

technician for help.

Some cordless telephones operate at frequencies

that may cause interference to nearby TVs and

VCRs. To minimize or prevent such interference,

the base of the cordless telephone should not be

placed near or on top of a TV or VCR. If

interference is experienced, move the cordless

telephone further away from the TV or VCR. This

will often reduce, or eliminate, interference.

FCC RF Exposure Warning:

This product complies with FCC radiation

exposure limits set forth for an uncontrolled

environment. To comply with FCC RF exposure

requirements the base unit must be installed and

operated with its antenna located 20 cm or more

between antenna and all person

’

s body

(excluding extremities of hands, wrist and feet).

The handset unit may be carried and operated

with only the specific provided belt-clip. Other

non-tested belt-clips or similar body-worn

accessories may not comply and must be

avoided. The base and handset units must not be

co-located or operated in conjunction with any

other antenna or transmitter.