Panasonic WVCU650 WJSX150 User Guide - Page 16

MULTIPLEXER OPERATIONS MUX Multiplexer board WJ-SXB151 is an optional board. It enables multiscreen display, electronic zooming, still picture and multiscreen sequence. It also enables the operation of Digital Disk Recorder WJHD100 Series or time-lapse VCR, when connected to them. Note: Before the use, it is necessary to install the Multiplexer board in the matrix switcher and configure the system through SETUP MENU and WJ-SX150A Administrator Console. (Refer to the operating instructions of matrix switcher.) ■ Monitoring the Camera Picture ● Multiscreen Segment Switching 1. Select the desired monitor. (Refer to p. 3 Monitor Selection.) 2. To select a Multiplexer, press the corresponding numeric button. Multiplexer board Master Multiplexer board Slave 1 Multiplexer board Slave 2 Multiplexer board Slave 3 Multiplexer board Slave 4 Multiplexer board Numeric button 0 (You can skip pressing this button.) 1 2 3 4 3. Press the RECORDER/UNIT button. The system will enter the recorder mode. The images from the recorder are displayed on the active monitor in multiscreen segments. 4. Press the MULTI SCREEN button. Every time you press the button, the multiscreen segment patterns are switched. (The following is the factory default setting.) 4 (segments) → 9 → 16 → 4 5. To return to the spot display, select the desired camera. Note: If you activate Quad Shift in Multiplexer Mode window of WJ-SX150A Administrator Console, the multiscreen segment patterns can be switched as follows. 4A (Page 1 of the quad - Camera 1, 2, 3, and 4) → 4B (Page 2 - Camera 5, 6, 7 and 8) → 4C (Page 3 Camera 9, 10, 11 and 12) → 4D (Page 4 - Camera 13, 14, 15 and 16) → 9 (segments) → 16 → 4A (Refer to the operating instructions of matrix switcher.) 16 ● Multiscreen Sequence Camera images are switched automatically in a sequence mode. The sequence mode (QUAD, 3+1, 8+1) is configurable through WJ-SX150A Administrator Console. (Refer to the operating instructions of matrix switcher.) 1. Enter the recorder mode. (Refer to Step 1 to 3 of Multiscreen Segment Switching.) 2. Press the TOUR SEQ/GROUP SEQ button. A sequence of multiscreen pictures is displayed according to the WJ-SX150A Administrator Console's configuration. 3. To cancel the sequence, press the MULTI SCREEN button. Note: The sequence can also be cancelled by selecting the desired camera. (In this case, you can automatically exit the recorder mode.) ● Still Multiscreen Picture Still pictures can also be displayed in a multiscreen. 1. Enter the recorder mode. (Refer to Step 1 to 3 of Multiscreen Segment Switching.) 2. Press the MENU repeatedly until "Mux Still" appears on the LCD. Mux Still 052 "Input Still CH" 3. Press the numeric button corresponding to the camera number. 4. Press the F1 button. The selected camera image will change into the still picture. "STILL" and the camera title alternately blink on the monitor. 5. To cancel the still picture, press the numeric button corresponding to the desired camera number, and then press the F1 button. Notes: • "STILL" does not appear when the still display is set to OFF. • When you skip Step 3 and do Step 4, all the channels displayed in the multiscreen segments will be changed into the still pictures.