Panasonic WVCU650 WJSX150 User Guide - Page 2

3. To select your registered operator ID number (1 to 16, up to 2 digits), press the numeric buttons, then press the CAM (SET) button. "Password" entry form appears on the LCD. User ID Password 150 _____ Note: The factory default setting is 150. 4. To select your registered password (up to 5 digits), press the numeric buttons, then press the CAM (SET) button. The factory default setting is "150". If the operator ID and password are correct, "Login OK" will blink on the LCD for about 3 seconds. Then, "Mon -" "Cam - -" will appear on the LED display. User ID Password 150 Mon- Cam-- Note: If an operator ID or password error occurs, "Invalid" will blink on the LCD for about 3 seconds. Then, return to Step 3 and select your operator ID. Invalid Blinking ■ Operation End (Logout) This operation is skipped when the auto logout is set to ON. This function is used when an operator leaves the controller or no longer requires access to the system. Terminal Mode No User To log out of the system, press the MON LOCK/LOGOUT button while holding down the SHIFT button. "Logout" will blink on the LCD for about 3 seconds. Then, "Terminal Mode No User" appears on the LCD. Note: If you want to save the power consumption, disconnect the DC 9 V plug from the controller, and remove the AC adapter from the AC outlet. ■ Operation End (Auto Logout) If the auto logout is set to ON and no operation takes place for a specific time, any operators can logout automatically. After the logout, "Terminal Mode No User" automatically appears on the LCD. Terminal Mode No User You can activate auto logout and set up the duration until logout (configurable by minute) through WJ-SX150A Administrator Console. (Refer to the operating instructions of matrix switcher.) ■ Operation Start (Auto Login) If the auto login is set to ON, any operators can log into the system automatically. After the controller is turned on, "Auto Login" appears on the LCD for approximately 2 seconds, then "Mon -" "Cam - -" automatically appears. Auto login is configurable through WJ-SX150A Administrator Console. (Refer to the operating instructions of matrix switcher.) Mon- Cam-- 2