Panasonic WVCU650 WJSX150 User Guide - Page 26
PLAY/PAUSE button, STOP button
UPC - 791871504277
View all Panasonic WVCU650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
• VMD search Recording events will be searched by the date and time when a camera detected the brightness-level change. Then, a result list or a thumbnail will be displayed. For playback, you will select a time and date displayed on the result list or thumbnail. Filtering is available by camera channel, date-and-time, detection area or search mode. 1. Enter the recorder mode. (Refer to p. 19 Recorder Mode.) 2. Repeat pressing the SEARCH/T&D SEARCH button until the VMD search list window is displayed on the monitor. The recorder will enter the searching mode. VMD SEARCH TIME&DATE APR.25.03*12:34:56 AM APR.25.03*12:34:56 AM APR.25.03*12:34:56 AM APR.25.03*12:34:56 AM APR.25.03*12:34:56 AM APR.25.03*12:34:56 AM APR.25.03*12:34:56 AM APR.25.03*12:34:56 AM CAM 01ch 01ch 01ch 01ch 01ch 01ch 01ch 01ch APR.25.03*12:34:56 AM APR.25.03*12:34:56 AM TOTAL 12345 TIME&DATE SEARCH REC EVENT SEARCH VMD SEARCH MARK 3. Press the CAM (SET) button. The VMD search window will be displayed on the monitor. ■ SELECT CAMERA & DATE CAMERA CAM1 START JAN . 1 . 03 12 : 00 AM END JAN . 1 . 03 12 : 00 AM SET : [SET] SEARCH : [PLAY] CANCEL : [ESC] 4. Enter a camera number and time range. Available controls and functions JogDial clockwise: Increments a parameter. JogDial counterclockwise: Decrements a parameter. + button: Increments a parameter. - button: Decrements a parameter. PLAY/PAUSE button: Executes the VMD search and returns to the upper menu. STOP button: Stops the VMD search. MON (ESC) or EXIT button: Cancels the VMD search and returns to the upper menu. 3D joystick upward (D): Moves the cursor up. 3D joystick downward (C): Moves the cursor down. 3D joystick leftward (A): Moves the cursor to the left. 3D joystick rightward (B): Moves the cursor to the right. 5. Press the CAM (SET) button. The motion detection area setup window will be displayed. Note: If no image was recorded in the time range set in step 4, the motion detection area setup window will not be displayed. 6. Select "SETUP AREA" on the status bar by performing either of the following. • Rotate the JogDial clockwise or counterclockwise. • Press the + or - button. A "+" mark will appear at the center of the monitor. Note: To set all displayed areas as motion detection areas, press the CAM (SET) button after selecting "ALL AREAS". 7. Move the "+" mark to a desired area with the 3D joystick, and then press the CAM (SET) button. The start point of motion detection area will be determined. 8. Move the "+" mark to another desired area with the 3D joystick, and then press the CAM (SET) button again. The end point of motion detection area will be determined. 9. To configure more motion detection areas, repeat Step 7 and 8. (Up to 4 motion detection areas are available.) 26