Ricoh Priport HQ9000 Operating Instructions - Page 169

Settings You Can Change with User Tools ❖ No.of ldling Rotations: Quality Start ❖ Master/Ink Remaining Volume When you use the Quality Start mode, you can select how many times the drum unit idles. Note ❒ Default: 7 times ❖ Deflector Angle You can change the angle of the wing guide depending on the paper type you use. • Up (Select this setting when standard thickness or thin paper misfeeds at the paper exit section occur frequently.) Specifies whether you can check the amount of ink and master. • [Off] (You cannot check the remaining amount of ink or master.) • [On (Below half)] (When the remaining amount of ink or master is less than half, the display panel indicates these amounts when you turn on the main switch.) Note ❒ Default: Off • Down (Select this setting when ❖ Paper Type A4 - B5 JIS, 81/2" × 11" thick pa- You can select the paper type. 5 per is not delivered properly to the paper delivery tray.) Note ❒ Default: Standard Note ❒ Default: Auto ❖ Paper Type: User1-2 You can register a frequently used ❖ Auto Class paper type and have it shown on Instead of using the Separate the paper type menu as [User 1] or mode, you can make the following [User 2]. settings: • Start Automatically (After the last page of each printing set is fed out to the paper delivery tray, the machine stops for a few seconds. Then, the next cycle begins.) • Stop (After the last page of each printing set is fed out to the paper delivery tray, the machine stops. If you press the {Start} key, the next cycle begins.) Note ❒ Default: Standard: No Feed A Select the paper type. • Standard: "No feed" "Double feed" • Thick Paper: "No feed" "Double feed" "Medium" B Press [OK]. Note ❒ Default: Stop 157