Sony VPLHS3 Operating Instructions - Page 36
Replacing the Lamp - lamp life
UPC - 027242628793
View all Sony VPLHS3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Replacing the Lamp 2 Open the lamp cover by loosening the screw with a Philips screwdriver. The lamp used for the light source has a certain life. When the lamp dims, the color balance of the picture becomes strange, or "Please replace the LAMP." appears on the screen, the lamp is exhausted. Replace the lamp with a new one (not supplied). Use LMP-H150 Projector Lamp as the replacement lamp. When replacing the lamp after using the projector Turn off the projector, then unplug the power cord. Wait for at least an hour for the lamp to cool completely. Caution The lamp becomes a high temperature after turning off the projector with the [/1 (on/standby) switch. If you touch the lamp, you may scald your finger. When removing the lamp unit, make sure it remains horizontal, then pull straight up. Do not tilt the lamp unit. If you pull out the lamp unit while tilted and if the lamp is broken, the pieces may scatter, causing injury. 1 Hold down the adjuster lock lever, slide it to the right, raise the rear of the projector, then return the adjuster lock lever. While keeping the screw on the bottom of the projector turned inward with a coin or a slotted screwdriver, open the projector cover with your hand. 3 Loosen the screw on the lamp unit with a Philips screwdriver. Holding the handle, pull the lamp unit straight up. 4 Insert the new lamp all the way in until it is securely in place. Tighten the screw, and fold down the handle. Note Be sure that the projector is stable. 5 Close the lamp cover and tighten the screw. Others 36 GB Replacing the Lamp