Yamaha PSR-S900 Owner's Manual - Page 193

Using Your Instrument with Other Devices P. 200 9 LAN P. 199 P. 198 87 USB TO DEVICE TO HOST P. 198 6 MIDI IN OUT P. 194 5 FOOT PEDAL 1 2 P. 194 3 VIDEO OUT 1 P. 193 2 P. 193 4 P. 194 CAUTION Before connecting the instrument to other electronic components, turn off the power of all the components. Also, before turning any components on or off, make sure to set all volume levels to minimum (0). Otherwise, electrical shock or damage to the components may occur. Connecting Audio & Video Devices n Use audio cables and adaptor plugs having no (zero) resistance. Using External Audio Devices for Playback (1 [OUTPUT] jacks) You can connect these jacks to a stereo system to amplify the instrument's sound. The microphone or guitar sound connected to the instrument's [MIC/LINE IN] jack is output at the same time. Use audio cables for connection as shown in the diagrams. These jacks are located on the underside jacks panel of the instrument. CAUTION • When the instrument's sound is output to an external device, first turn on the power to the instrument, then to the external device. Reverse this order when you turn the power off. • Do not route the output from the [OUTPUT] jacks to the [AUX IN] jacks. If you make this connection, the signal input at the [AUX IN] jacks is output from the [OUTPUT] jacks. These connections could result in a feedback loop that will make normal performance impossible, and may even damage both pieces of equipment. When these are connected, you can use the instrument's [MASTER VOLUME] control to adjust the volume of the sound output to the external device. Connect the instrument's OUTPUT [L/L+R]/[R] jacks (standard phone jacks) and the input jacks of a pair of powered speakers using appropriate audio cables. Use only the [L/L+R] jack for connection with a monaural device. Instrument Powered speakers Phone plug (standard) Audio cable Input jack Phone plug (standard) Playing External Audio Devices with the Built-in Speakers (2 [AUX IN] jacks) The stereo outputs from another instrument can be connected to these jacks, allowing the sound of an external instrument to be reproduced via the instrument's speakers. Connect the output jacks (LINE OUT etc.) of an external synthesizer or the tone generator module and the instrument's AUX IN [L/L+R]/[R] jacks using appropriate audio cables. Instrument Phone plug (standard) Synthesizer Tone generator LINE OUT Pin plug Audio cable CAUTION When the sound of an external device is output to the instrument, first turn on the power to the external device, then to the instrument. Reverse this order when you turn the power off. n • Use only the [L/L+R] jack for connection with a monaural device. • The instrument's [MASTER VOLUME] setting affects the input signal from the [AUX IN] jacks. PSR-S900/S700 Owner's Manual 193 Using Your Instrument with Other Devices