ZyXEL P-660HNU-F1 User Guide - Page 158
Add/Edit Static Route, Table 37, LABEL, DESCRIPTION
View all ZyXEL P-660HNU-F1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
Chapter 8 Routing Figure 73 Network Setting > Routing The following table describes the labels in this screen. Table 37 Network Setting > Routing LABEL Add New Static Route # Active DESCRIPTION Click this to set up a new static route on the ZyXEL Device. This is the number of an individual static route. This indicates whether the rule is active or not. Status Name Destination IP Gateway Subnet Mask Interface Modify A yellow bulb signifies that this static route is active. A gray bulb signifies that this static route is not active. This shows whether the static route is currently in use or not. A yellow bulb signifies that this static route is in use. A gray bulb signifies that this static route is not in use. This is the name that describes or identifies this route. This parameter specifies the IP network address of the final destination. Routing is always based on network number. This is the IP address of the gateway. The gateway is a router or switch on the same network segment as the device's LAN or WAN port. The gateway helps forward packets to their destinations. This parameter specifies the IP network subnet mask of the final destination. This is the WAN interface through which the traffic is routed. Click the Edit icon to go to the screen where you can set up a static route on the ZyXEL Device. Click the Delete icon to remove a static route from the ZyXEL Device. 8.2.1 Add/Edit Static Route Click add new Static Route in the Routing screen or click the Edit icon next to a rule. The following screen appears. Use this screen to configure the required information for a static route. Figure 74 Routing: Add/Edit 158 ADSL Series User's Guide