2014 Chevrolet Impala Owner Manual - Page 306

10-32 Vehicle Care 6. Install a new bulb in the lamp assembly. 7. Connect the electrical connector. 8. Replace the cap on the back of the headlamp assembly by turning it clockwise. 9. For the driver side, reinstall the windshield washer bottle filler neck by firmly pushing it straight into the bottle. Ensure that the filler neck clip engages into the underhood electrical center retainer. To replace one of the headlamp bulbs: 1. Open the hood. See Hood on page 10-4. 2. For the driver side bulb, remove the windshield washer bottle filler neck by firmly pulling it straight up and out of the bottle. 3. Remove the cap from the back of the headlamp assembly by turning it counterclockwise. Driver Side Shown, Passenger Side Similar 1. Sidemarker Lamp 2. Parking/Turn Signal Lamp Uplevel Headlamp Assembly The uplevel model vehicle has a high intensity discharge (HID) high/ low beam headlamp, a parking/turn signal lamp, and a sidemarker lamp on the headlamp assembly. 4. Disconnect the electrical connector. 5. Remove the bulb from the lamp assembly by turning counterclockwise. For replacement of the headlamp on an HID assembly, contact your dealer. See High Intensity Discharge (HID) Lighting on page 10-31. Front Turn Signal, Parking, and Sidemarker Lamps To replace one of these lamps on a base, or uplevel assembly: 1. For the driver side bulb, remove the windshield washer bottle filler neck by firmly pulling it straight up and out of the bottle. 2. Remove the bulb socket from the headlamp assembly by turning it counterclockwise.