2014 Chevrolet Impala Owner Manual - Page 308
2014 Chevrolet Impala Manual
Page 308 highlights
10-34 Vehicle Care { Caution Improper lamp assembly removal and installation can cause leaks and water intrusion which may cause damage to the taillamp. Do not remove the taillamp assembly to replace a bulb. Use the trunk opening to access the bulb. To replace one of these bulbs: 1. Open the trunk. See Trunk on page 2-14. 2. Remove the push pins and pull the trunk trim away from the taillamp assembly. 3. Remove the bulb socket from the taillamp assembly by turning it counterclockwise. 4. Remove the bulb from the socket by turning the bulb counterclockwise one-quarter turn and pulling it straight out. 5. Install a new bulb into the socket. 6. Install the bulb socket into the taillamp assembly by turning it clockwise. 7. Install the trunk trim and push pins. License Plate Lamp To replace one of these bulbs: 3. Turn the bulb socket (1) counterclockwise to remove it from the lamp assembly (3). 4. Pull the bulb (2) straight out of the bulb socket. 5. Push the replacement bulb straight into the bulb socket and turn the bulb socket clockwise to install it into the lamp assembly. 6. Push the lamp assembly back into position until the release tab locks into place. Passenger Side Shown, Driver Side Similar 1. Push the lamp assembly toward the right. 2. Pull the lamp assembly down to remove.