2014 Chevrolet Impala Owner Manual - Page 345
2014 Chevrolet Impala Manual
Page 345 highlights
Vehicle Care 10-71 Jump Starting Jump Starting (On-board with eAssist Only) If the vehicle fails to crank, it may be jump started by using the eAssist battery to charge the 12-volt battery. Use the following procedure to activate the on-board jump start using the DIC controls. DIC Buttons The vehicle may be equipped with an ignition key or an electronic keyless ignition with pushbutton start. Key Access Place the ignition key in the ON/ RUN position and proceed as follows: 1. Press o then scroll w or x until the Settings menu displays. 2. Press V to enter the Settings menu. 3. Press p then scroll w or until Jump Start displays. 4. Press start. x V to activate the jump 5. The system will then ask for confirmation. If Yes is selected, the jump start will begin and the display will show WAIT TO START. 6. When the jump start is complete, the display will show ATTEMPT START or JUMP START DISABLED. Keyless Access With the brake pedal not applied, press and hold the ENGINE START/ STOP button for more than five seconds. This will place the vehicle in the Service Only Mode. Proceed as follows: 1. Press o then scroll w or x until the Settings menu displays. 2. Press V to enter the Settings menu.