2003 Lincoln Navigator Owner Guide 1st Printing (Spanish) - Page 545

Driver Controls Note: You will need to wait 2 seconds after opening the liftgate to begin manually closing the power liftgate. Obstacle detection The power liftgate system is equipped with an obstacle detection feature. If the power liftgate is closing, the system is designed to reverse to full open when it encounters a solid obstacle. Once the obstacle is removed, the liftgate can be closed under power. If the power liftgate is opening, the system is designed to stop when it encounters a solid obstacle. If the liftgate stops below the half open position, you will need to close and fully latch the liftgate manually. Normal operation can then be resumed. Resetting the power liftgate: The power liftgate may not operate under these conditions. • a low voltage or dead battery • disconnected battery • the liftgate has been left open for more than six (6) hours. To reset the power liftgate: 1. Manually close and fully latch the liftgate. 2. Power open the liftgate by using the keyfob or overhead console button. 3. Once the liftgate is fully open, close the liftgate using the keyfob or overhead console button. Note: If the power liftgate system is turned in the message center, the system can not be activated with any switches or with the liftgate handle. The system will need to be turned for any power operation to occur. Liftgate ajar signal If the liftgate or liftgate glass are not fully latched, you will receive a "LIFTGATE AJAR" message on the instrument panel. If you see this message, check both the liftgate glass and liftgate door to insure they are fully latched. 154