Adaptec ANA-62022 User Guide - Page 102
Assigning the Protocols, Viewing the Configuration
UPC - 760884132333
View all Adaptec ANA-62022 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Duralink64 Standalone Driver for UnixWare 15 Repeat Steps 8 through 14 for additional LAN configurations. 16 To exit, click Hardware, then select Exit. Assigning the Protocols To assign IP or IPX protocols to standalone ports, follow these steps: Note: The IPX protocol supports all four frame types and multiple-frame types simultaneously. IP protocol supports either Ethernet_II or Ethernet_SNAP, but not both at the same time. Adding IPX/SPX requires a system reboot. 1 Select Add Protocol from the Network Configuration Manager menu. 2 From the Protocol menu, select IPX/SPX or TCP/IP. 3 Click Add. 4 Enter the network configuration, and click OK. Repeat Steps 1 through 3 for each additional protocol. Viewing the Configuration It is important to verify the current port configurations before saving them to the server. To verify the current port configurations, follow these steps: 1 Select the Protocol option from the Network Configuration Manager menu, and press Enter. 2 Select View Protocol Configuration. 3 If the setup is correct, click OK. 4 To exit, click Hardware, then select Exit. 7-3