Adaptec ANA-62022 User Guide - Page 125

The Diagnostics Utility Command hbi_slave hbi_dma mac address_filter internal_10_mac internal_100_mac internal_10_phy internal_100_phy external_10 external_100 autonegotiate (speed is one of five options) checksum statistics Test Tests slave accesses, checks serial EEPROM, and checks register accesses to the chip. Checks DMA transfers to and from the board. Tests registers and various functions of Ethernet controller. Tests Ethernet packet filtering capabilities. Tests internal loop-back at 10 Megabits/sec within the chip. Test internal loop-back at 100 Megabits/sec within the chip. Tests loop-back from the physical device at 10 Megabits/sec. Tests loop-back from the physical device at 100 Megabits/sec. This test requires a loop-back cable. It tests the loop-back from the cable at 10 Megabits/sec. This test requires a loop-back cable. It tests the loop-back from the cable at 100 Megabits/sec. Tests the speed the card negotiates. This test has five options: 0 - Tests for full autonegotiation (highest speed) 10 - Forces test at 10 Megabits/sec half duplex 20 - Forces test at 10 Megabits/sec full duplex 100 - Forces test at 100 Megabits/sec half duplex 200 - Forces test at 100 Megabits/sec full duplex Note: Requires a hub, switch, or loop-back cable. Also, autonegotiate defaults to 10 MB if the cable is not connected. Tests the abilitiy to calculate TCP/IP checksum. Verifies statistics gathering features of the chip. D-3