Adaptec ANA-62022 User Guide - Page 58
Configuring the Failover Pair in Windows NT 4.0, Apply, Remove
UPC - 760884132333
View all Adaptec ANA-62022 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Duralink64 Configurations for Windows 7 To add the second port, repeat Step 6. Note: To add multiple ports at one time, hold down the Ctrl key, select the appropriate ports, and click Add. Only two ports per group are supported for Failover. To assign TCP/IP addresses to your ports, refer to Assigning the TCP/IP Address on page 4-16. Configuring the Failover Pair in Windows NT 4.0 To create Failover pairs in Windows NT 4.0, follow these steps: 1 From the Available Adaptec Ports list, select the port to be designated as the primary port, and click Add. The port is added under Primary Port field in the Pair Port list. 2 To assign a backup to the primary port, select the appropriate port from the Available Adaptec Ports list, and click Add. The port is added in the Backup Port list. 3 Click Apply. 4 OPTIONAL. Create another Failover pair by repeating Steps 1 through 3. 5 OPTIONAL. Remove a Failover pair by selecting the port from the Primary Ports list; then click Remove. Both ports return to the Available Adaptec Ports list. Click Apply. 4-9