Adaptec ANA-62022 User Guide - Page 72
Remove, Apply, Close, message such as the ones shown below. Click
![]() |
UPC - 760884132333
View all Adaptec ANA-62022 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Duralink64 Configurations for Windows - To remove ports from the group, select the appropriate port from the Group Ports box, and click Remove. 3 Repeat Step 2 for each appropriate port. 4 To save changes, click Apply. 5 When you are finished, click OK. 6 If SNMP is not set up on the computer, you will receive the Setup Message below. Ignore the message, and click OK. 7 When adding or removing a group or port, you will receive a message such as the ones shown below. Click OK. This message appears when you add ports with IP addresses to a new group. This message appears when you add ports with IP addresses to Group2 with an existing IP address. 8 In the Network window, click Close. 4-23
![](/manual_guide/products/adaptec-ana62022-user-guide-754ab88/72.png)
4-23
Duralink64 Configurations for Windows
–
To remove ports from the group, select the appropriate port
from the Group Ports box, and click
Remove
.
3
Repeat Step 2 for each appropriate port.
4
To save changes, click
Apply
.
5
When you are finished, click
OK
.
6
If SNMP is not set up on the computer, you will receive the
Setup Message below. Ignore the message, and click
OK
.
7
When adding or removing a group or port, you will receive a
message such as the ones shown below. Click
OK
.
This message appears when you add ports with IP addresses to
a new group.
This message appears when you add ports with IP addresses to
Group2 with an existing IP address.
8
In the Network window, click
Close
.