Adaptec ANA-62022 User Guide - Page 87
Installing the NetWare Port Aggregation and Failover Drivers, Configuring the Ports
![]() |
UPC - 760884132333
View all Adaptec ANA-62022 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Duralink64 Drivers for NetWare Installing the NetWare Port Aggregation and Failover Drivers If you are installing NetWare 6.0 or 5.x on a new server, please see Installing the Duralink64 Driver during NetWare 6.0/5.x OS Installation on page 5-5. Note: This driver uses 64 receive buffers for each port. Therefore, if you are using multiple ports, the number of receive buffers must be increased. Type load edit c:\nwserver\startup.ncf then type the following commands at the end of the file: set minimum packet receive buffers = 2000 set maximum packet receive buffers = 10000 To install the Failover or Port Aggregation driver for NetWare, follow these steps: 1 Insert the Duralink64 NetWare CD into the CD-ROM. 2 Mount the CD-ROM, refer to NetWare documentation (as per your specific OS). To display the CD volume name, type the volume at the console prompt. 3 To run the config program, type the name of the CD volume followed by \nwserver\configsf. For example, type load duralink64v52:\nwserver\configsf and press Enter. 4 When the Duralink64 screen appears, select the Install Software option, and press Enter. Note: If a dialog box appears requesting to overwrite any files, press F5 to overwrite all previous files. Configuring the Ports To configure the ports, follow these steps: 1 From the Main Menu, select Link Aggregation Type, select Configure Ports, and press Enter. 5-7
![](/manual_guide/products/adaptec-ana62022-user-guide-754ab88/87.png)