Alpine CDA-9887 Owners Manual - Page 44
To prevent external noise from entering the audio system.
UPC - 793276711373
View all Alpine CDA-9887 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
The X-Over Switch position for a 4.2ch system (frequency range is divided between highs for front/rear and lows for the Subwoofer). The position of the X-Over switch: F/R/Sub-W Front high range speaker (L) Rear high range speaker (L) Low range speaker (L) Front high range speaker (R) Rear high range speaker (R) Low range speaker (R) The X-Over Switch position for a 2.2ch system whose frequency range is divided among the highs (Rear), mids (Front), and lows (Subwoofer). The position of the X-Over switch: 3WAY Mid range speaker (L) High range speaker (L) Low range speaker (L) Mid range speaker (R) High range speaker (R) Low range speaker (R) Output of this unit: Front output • Use the Sub-W output cord to connect the unit to the low range speaker. • You can use the built-in amplifier to output the front output/rear output. • You cannot adjust the fader when set to 3WAY. Rear output SUB-W output To prevent external noise from entering the audio system. • Locate the unit and route the leads at least 10 cm away from the car harness. • Keep the battery power leads as far away from other leads as possible. • Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis. • If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information. • Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information. 42-EN