Alpine ICS-X7HD Owner's Manual (english) - Page 80

Radio Antenna Receptacle Remote Control Output Lead (Brown) Connect this lead to the remote control input lead. This lead outputs the controlling signals from the remote control. Reverse Lead (Orange/White) Connect to the plus side of the car's reverse lamp. This lamp illuminates when the transmission is shifted into reverse (R). With this lead properly wired, the video picture automatically switches to the rear camera whenever the car is put into reverse (R). CAMERA Connector Video Input Connector (AUX INPUT) (Yellow) Input the video or camera. Audio Input Connectors (AUX INPUT) RED is right and WHITE is left input the audio. Rear Output RCA Connectors It can be used as Rear Output RCA Connectors. RED is right and WHITE is left. Front Output RCA Connectors It can be used as Front Output RCA Connectors. RED is right and WHITE is left. Subwoofer RCA Connectors RED is right and WHITE is left. RCA Extension Cable (sold separately) Steering Remote Control Interface Connector To steering remote control interface box. For details about connections, consult your nearest Alpine dealer. AUX/PRE OUT Connector SiriusXM Tuner connector Connect to a SiriusXM Tuner. Refer to additional installations instructions included with the SiriusXM tuner. iPod VIDEO Input Connector Input the iPod/ iPhone video signal or AUX video/audio signal. • Set "AUX3 In Sel." (page 33) to "iPod Video" when an iPod/iPhone is connected. • Set "AUX3 In Sel." (page 33) to "AUX3" when AUX video/ audio is input. USB Connector To USB Memory, iPod/iPhone or Mobile Phone. MIC Input Connector To Microphone (Included). Power Supply Connector Remote Turn-On Lead (Blue/White) Connect this lead to the remote turn-on lead of your amplifier or signal processor. Audio Interrupt In Lead (Pink/Black) Not used for this unit. Parking Brake Lead (Yellow/Blue) Connect this lead to the power supply side of the parking brake switch to transmit the parking brake status signals to the ICS-X7HD. Foot Brake Lead (Yellow/Black) Connect to the vehicle's foot brake lead or brake lamp lead. Power Antenna Lead (Blue) Connect this lead to the +B terminal of your power antenna, if applicable. • This lead should be used only for controlling the vehicle's power antenna. Do not use this lead to turn on an amplifier or a signal processor, etc. Switched Power Lead (Ignition) (Red) Connect this lead to an open terminal on the vehicle's fuse box or another unused power source which provides (+) 12V only when the ignition is turned on or in the accessory position. Ground Lead (Black) Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided. Battery Lead (Yellow) Connect this lead to the positive (+) post of the vehicle's battery. Fuse Holder (10A) Left Rear (+) Speaker Output Lead (Green) Left Rear (-) Speaker Output Lead (Green/Black) Left Front (+) Speaker Output Lead (White) Left Front (-) Speaker Output Lead (White/Black) Right Front (-) Speaker Output Lead (Gray/Black) Right Front (+) Speaker Output Lead (Gray) Right Rear (-) Speaker Output Lead (Violet/Black) Right Rear (+) Speaker Output Lead (Violet) NAVI Connector Not used for this unit. 80-EN