Campbell Scientific CR10 CR10 Measurement and Control - Page 59
Editor
View all Campbell Scientific CR10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
TABLE 3.10-1. Error Codes Code Type Description 03 Editor program table full 04 Compile Intermediate Storage full 05 Compile Storage Area #2 not 08 Time allocated Run CR10 reset by watchdog timer 09 Time Run lnsufficient Input Storage 11 Editor Attempt to allocate more Input or Intermediate Storage than is available 20 Compile SUBROUTINE encountered before END of previous subroutine 21 Compile END without lF, LOOP or SUBROUTINE 22 Compile Missing END 23 Compile Nonexistent SUBROUTINE 24 Compile ELSE in SUBROUTINE without lF 25 Compile ELSE without lF 26 Compile EXIT LOOP without LOOP 27 Compile lF CASE without BEGIN CASE 30 Compile lF and/or LOOP nested 31 Time too deep Flun SUBROUTINES nested too deep 40 Editor Instruction does not exist 41 Editor Inconect execution interual 60 Compile Inadequate Input Storage for FFT 61 Compile Burst Measurement Scan Rate too short 96 "D MODE Addressed device not 97 .D MODE connected Data not received within 98 .D MODE 30 seconds Uncorrectable errors detected 99 *D MODE Wrong file type or editor error SECTION 3. INSTRUCTION SET BASICS 3-9