Canon DR-7080C User Manual - Page 89

Scanner Status Messages

Get Canon DR-7080C PDF manuals and user guides View all Canon DR-7080C manuals
Add to My Manuals
Save this manual to your list of manuals

Page 89 highlights

6.4 Display Messages Scanner Status Messages The following messages indicate the current status of the scanner: Display Status The scanner is performing some process. Please wait. Display Status Display The scanner is in the Ready Mode. The scanner will go into the Stand-by Mode if you do not perform any operation for approximately 10 minutes. Status Display Status Display The scanner is in the Stand-by Mode. A signal from the computer or an operation panel key operation will recover the scanner to Ready Mode. The scanner is in the Count Only Mode. (See "Using the Count Only Mode," on p. 63.) Status The scanner is in the Job Mode. Press the [Start] key to start scanning or the [Stop] key to exit the Job Mode. (See "Using the Job Mode for Scanning," on p.59.) 6 85

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
85
6
Scanner Status Messages
The following messages indicate the current status of the scanner:
Display
Status
The scanner is performing some process. Please wait.
Display
Status
The scanner is in the Ready Mode. The scanner will go into the
Stand-by Mode if you do not perform any operation for
approximately 10 minutes.
Display
Status
The scanner is in the Stand-by Mode. A signal from the computer or
an operation panel key operation will recover the scanner to Ready
Mode.
Display
Status
The scanner is in the Count Only Mode. (See “Using the Count
Only Mode,” on p. 63.)
Display
Status
The scanner is in the Job Mode. Press the [Start] key to start
scanning or the [Stop] key to exit the Job Mode. (See “Using the
Job Mode for Scanning,” on p.59.)
6.4
Display Messages