Canon EOS 70D Operation Manual - Page 432

Error Codes Error number If there is a problem with the camera, an error message will appear. Follow the onscreen instructions. Cause and countermeasures Number Error Message and Solution Communications between the camera and lens is faulty. Clean the lens contacts. 01 Î Clean the electrical contacts on the camera and lens, use a Canon lens, or remove and install the battery pack again (p.19, 20, 30). Card cannot be accessed. Reinsert/change card or format card with camera. 02 Î Remove and insert the card again, replace the card, or format the card (p.31, 57). Cannot save images because card is full. Replace card. 04 Î Replace the card, erase unnecessary images, or format the card (p.31, 57, 322). The built-in flash could not be raised. Turn the camera off and on 05 again. Î Operate the power switch (p.35). Sensor cleaning could not be performed. Turn the camera off and 06 on again. Î Operate the power switch (p.35). 10, 20 30, 40 50, 60 70, 80 99 An error prevented shooting. Turn the camera off and on again or re-install the battery. Î Operate the power switch, remove and install the battery pack again, or use a Canon lens (p.30, 35). * If the error still persists, write down the error number and contact your nearest Canon Service Center. 432