Canon PowerShot S10 Software Starter Guide - Page 14

Installing the Driver Software - drivers

Get Canon PowerShot S10 PDF manuals and user guides View all Canon PowerShot S10 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Installing the Driver Software (Preinstalled Windows 98 Systems) First USB Connection Only Note Regarding Installation • The driver installation process will install two programs: USB Driver and PowerShot USB TWAIN Driver. • Do not cancel the installation partway through. Allow the procedure to finish completely before exiting. The camera may not operate correctly if the installation is incomplete. • The driver installation is only required the first time the camera is connected via the USB interface. It is not required from the second time onward. • Your computer may prompt you to insert the CD-ROM containing your Windows system software during the installation. Have the Windows disk handy in case it is required. 1. Attach the PowerShot S10/S20 to the computer's USB port and turn the mode dial to the position ( p. 8). The [Add New Hardware Wizard] will appear after a moment. 2. Read the dialog and click the [Next] button. The dialog will change to the search selection dialog. What to Do if the Installation Does Not Proceed Properly Read the Troubleshooting the Driver Software Installation section on page 30 if the installation cancels itself during the procedure, if the installation does not proceed as described in these procedures, or if you think that the drivers are not properly installed. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
10
•
Your computer may prompt you to insert the CD-ROM containing your Windows system
software during the installation. Have the Windows disk handy in case it is required.
1.
Attach the PowerShot S10/S20 to the computer's USB port and turn the
mode dial to the
position (
p. 8).
The [Add New Hardware Wizard] will appear after a moment.
2.
Read the dialog and click the [Next] button.
The dialog will change to the search selection dialog.
What to Do if the Installation Does Not Proceed Properly
Read the Troubleshooting the Driver Software Installation section on page 30 if the
installation cancels itself during the procedure, if the installation does not proceed as
described in these procedures, or if you think that the drivers are not properly installed.
Installing the Driver Software
(Preinstalled Windows 98 Systems)
First USB Connection Only
Note Regarding Installation
•
The driver installation process will install two programs: USB Driver and
PowerShot USB TWAIN Driver.
•
Do not cancel the installation partway through. Allow the procedure to finish completely
before exiting. The camera may not operate correctly if the installation is incomplete.
•
The driver installation is only required the first time the camera is connected via the
USB interface. It is not required from the second time onward.