Cisco ASR1002 Quick Start Guide - Page 14
Install the Cables Using the Cable-Management Bracket - esp
UPC - 882658196416
View all Cisco ASR1002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Install the Cables Using the Cable-Management Bracket Cables coming off the front side of the Cisco ASR 1002-F integrated RP and SPAs utilize the chassis-level cable-management brackets provided on the chassis rack-mount brackets (see Figure 11). To secure SPA cables and input or output cables connected to the Cisco ASR 1002-F Router, follow these steps: Step 1 When installing the network interface cables, route the cables up to and through the cable-management bracket 'U' device. If you are using very thin cables that slip through the bracket openings, insert nylon cable ties through the holes in the bracket and wrap them around the cables to secure them as shown in Figure 11. Figure 11 Cisco ASR 1002-F Integrated Route Processor Cable Management 123 4 5 0 A/L C/A 1 A/L C/A 2 A/L C/A 3 A/L C/A STATUS 274949 SPA-4XOC3-POS 0 6 5 1 Building Integrated Timing Source cable 2 Management Ethernet cable 3 Console cable 4 Auxiliary cable 5 Cable-management "U" feature 6 Tie wrap for cables Step 2 Step 3 Route the excess cable out through either end of the bracket, coil it, and secure it to the rack using nylon cable ties or some other mode of attachment. It might be necessary to bundle longer cables to avoid tangling them. Do this at the cable-management bracket or at the rack, but leave enough slack in the cables to remove a Cisco ASR 1002-ESP-F and change cables as required. Also, do not block the power supply air vents with cables. 14