Cisco ASR1002 Quick Start Guide - Page 23

Feb 13 13:01:34.034: %ASR1000_OIR-2-INSSPA: SPA inserted in subslot *Feb 13 13:01:34.370: %SYS-5-RESTART: System restarted -Cisco IOS Software, IOS-XE Software (PPC_LINUX_IOSD-ADVENTERPRISEK9-M), Version 12.2(33)XNA, RELEASE SOFTWARE Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2008 by Cisco Systems, Inc. Compiled Thu 01-May-08 00:29 by mcpre*Feb 13 13:01:36.253: %DYNCMD-7-CMDSET_LOADED: The Dynamic Command set has been loaded from the Shell Manager *Feb 13 13:01:36.326: %CRYPTO-6-ISAKMP_ON_OFF: ISAKMP is OFF Router> Note You have the option of proceeding with the setup command facility to configure the interfaces or exiting from setup and using configuration commands to configure global (system-wide) and interface-specific parameters. You do not have to configure the interfaces immediately; however, you cannot enable the interfaces or connect them to any networks until you have configured them. For detailed software configuration information, see the Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide. 8 Configure the Router Use this section for information on configuring the Cisco ASR 1002-F Router. Using the Console to Access the CLI To access the command-line interface using the console, follow these steps: Your system is booting and if you answer No, at the prompt: --- System Configuration Dialog --Would you like to enter the initial configuration dialog? [yes/no]: no Step 1 Step 2 Step 3 Press Return to enter user EXEC mode. The following prompt appears: Router> From user EXEC configuration mode, enter the enable command as shown in the following example: Router> enable At the password prompt, enter your system password. If an enable password has not been set on your system, this step may be skipped. The following example shows entry of the password called enablepass: Password: enablepass Step 4 When your enable password is accepted, the privileged EXEC configuration mode prompt appears: Router# Step 5 You now have access to the CLI in privileged EXEC mode and you can enter the necessary commands to complete your desired tasks. 23