Cisco ASR1002 Quick Start Guide - Page 29

Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030 Powering Off the Cisco ASR 1002-F Router Safely This section explains how to shut down the Cisco ASR 1002-F Router. It is recommended that before turning off all power to the chassis, you issue the reload command. This insures that the operating system cleans up all the file systems. Once the reload operation is complete, then the Cisco ASR 1002-F Router can be powered off safely. To remove power from a Cisco ASR 1002-F Router safely, follow this procedure and see the examples: Step 1 Step 2 Step 3 Slip on the ESD-preventative wrist strap that was included in the accessory kit. Enter the reload command. Confirm the reload command: Rmcp-2ru-1#reload Proceed with reload? [confirm] Aug 17 00:06:47.051 R0/0: %PMAN-5-EXITACTION: Process manager is exiting: prs exit with reload chassis code Step 4 After confirming the reload command, wait until the system bootstrap message displays before powering off the system. System Bootstrap, Version 12.2(33r)XN2, RELEASE SOFTWARE (fc1) Technical Support: tap://www.cisco.com/techsupport Copyright (c) 2010 by cisco Systems, Inc. Current image running: Boot ROM0 Last reset cause: LocalSoft ASR1000-RP1 platform with 4194303 Kbytes of main memory mcp-2ru-1-rp0-rommon 1> Step 5 Remove any power cables from the Cisco ASR 1002-F Router. a. For power supplies with a circuit breaker switch, position the switch to the Off (O) position. b. For power supplies with a Standby switch, place the Standby switch in the Standby position. Note After powering off the router, wait a minimum of 30 seconds before powering it on again. Replace the Shared Port Adapters The shared port adapter (SPA) on the integrated Cisco ASR1002-SIP10-F in the Cisco ASR 1002-F Router support online insertion and removal (OIR); but the integrated Cisco ASR1002-SIP10-F does not support OIR and is not field-upgradeable. Before removing any shared port adapter, shut down the interface so that there is no traffic running through the shared port adapter when it is removed. Removing a shared port adapter while traffic is flowing through the ports can cause system disruption. Step 1 Attach an ESD wrist strap between you and an unpainted chassis surface. Step 2 Disconnect all cables from the shared port adapter. 29