Cisco ASR1002 Quick Start Guide - Page 17

Table 1 describes the AC power supply LEDs on the Cisco ASR 1002-F Router. Table 1 Cisco ASR 1002-F Router AC Power Supply LEDs LED Label INPUT OK FAN OK OUTPUT FAIL LED Power supply activity Color Green Flashing None Power supply fan activity Green Red Power supply activity Red Off Description The AC input voltage is greater than 85V. For an AC input voltage between 70V and 85V the INPUT OK LED can be on, off, or flashing. The AC input voltage is less than 70V or the power supply is turned off. All fans are operational. A fan failure is detected. DC output voltages are within the normal operating range. Output voltages below the minimum or above the maximum create an output fail alarm. No power to the power supply. Note To connect an AC power supply to the Cisco ASR 1002-F Router, follow the steps in the Installing the AC Power Supply, page 31. Connect DC Power to the Cisco ASR 1002-F Router The DC power supply input connector is a euro-style terminal block. A tab on the back of the power supply provides strain relief to the input wires on the power supply. The connection order is negative (-), positive (+), and ground (GND). Figure 14 shows the DC power supply for the Cisco ASR 1002-F Router. Figure 14 DC Power Supply for the Cisco ASR 1002-F Router 12 34 5 6 0 OUTPUT INPUT FAN FAIL OK OK This unit might have more than one power supply connection. All connections must be removed to de-energize the unit. OUTPUT INPUT FAN FAIL OK OK This unit might have more than one power supply connection. All connections must be removed to de-energize the unit. 280289 -48V/-60V 16A 10 9 8 1 Chassis ESD socket 2 DC power supply slot 0 label 3 Standby switch 4 DC power supply LEDs 5 Fan 1 -48V/-60V 16A 7 6 Captive installation screw 7 DC power supply slot 1 label 8 Earth ground lead 9 Positive ground lead 10 Negative ground lead 17