Cisco SRW2024P User Guide - Page 32

Chapter 5 Advanced Configuration PVE When a port is a Private VLAN Edge (PVE) port, it bypasses the Forwarding Database and forwards all unicast, multicast, and broadcast traffic to an uplink. NOTE: All ports in the same PVE group should join the same VLAN group. LAG (Read-only) The LAG to which this port belongs, if the port is a LAG member. Click Save to save the settings and leave the screen open. Click Save & Close to save the settings and close the screen. Click Close to close the screen without saving the settings. Port Management > Link Aggregation Port Management > Link Aggregation LAG The LAG number (1-8). Description The user-defined description for the LAG. Admin Status The administrative status of the LAG. Up indicates that the LAG is available. Down indicates that administrator has taken the port offline. When modifying the option, click Save Settings. Type Indicates if a LAG has been manually configured (static) or dynamically set through LACP. Link Status Displays the status of the link. Speed Displays the port speed. Duplex Displays the duplex mode. Flow Control Displays the flow control status of the LAG. It is active when the port uses Full Duplex Mode. LAG Mode Displays the LAG status: On, Off, or Not Present. Detail To create a new LAG, click Detail in the Detail column to display the Link Aggregation detail screen. WebView Switches Link Aggregation > Detail Link Aggregation > Detail LAG Configuration LAG The LAG number (1-8). To display or edit another LAG, select the number from the drop-down menu. Description The user-defined LAG description of up to 64 characters. This field is blank by default. LACP Select the checkbox to enable Link Aggregation Control Protocol (LACP). LAG Type (Read-only) The LAG type. Administrative Status The LAG's administrative status. Select either Up or Down to enable or disable the LAG. Current Status (Read-only) The LAG's status, either Up or Down. Reactivate Suspended LAG If the LAG has been suspended, select this checkbox to reactivate the LAG. Operational Status (Read-only) Displays whether the LAG is operational or non-operational. Admin Auto Negotiation Enables or disables Auto Negotiation on the LAG. Auto-negotiation is a protocol between two link partners that enables a LAG to advertise its transmission rate, duplex mode and flow control (the flow control default is disabled) abilities to its partner. Current Auto Negotiation The current Auto Negotiation setting. Admin Speed The configured speed at which the LAG is operating. Current LAG Speed (Read-only) The current speed at which the LAG is operating. Admin Flow Control Enables or disables flow control or enables the auto negotiation of flow control on the LAG. Current Flow Control (Read-only) The current flow control setting. PVE Displays the PVE group to which the LAG is configured. 25