Compaq dx7500 Service Reference Guide: HP Compaq dx7500 Business PC - Page 72
Drives, Drive Positions
![]() |
View all Compaq dx7500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Drives The computer supports up to five drives that may be installed in various configurations. This section describes the procedure for replacing or upgrading the storage drives. A Torx T-15 screwdriver is needed to remove and install the guide screws on a drive. Drive Positions Figure 7-14 Drive Positions 1 Two 5.25-inch external drive bays for optional drives (optical drives shown) 2 One 3.5-inch external drive bay for optional drive (media card reader shown) 3 Primary 3.5-inch internal hard drive bay 4 Secondary 3.5-inch internal hard drive bay for optional hard drive 62 Chapter 7 Removal and Replacement Procedures Microtower (MT) Chassis
![](/manual_guide/products/compaq-dx7500-service-reference-guide-hp-compaq-dx7500-business-pc-72345e2/72.png)
Drives
The computer supports up to five drives that may be installed in various configurations.
This section describes the procedure for replacing or upgrading the storage drives. A Torx T-15
screwdriver is needed to remove and install the guide screws on a drive.
Drive Positions
Figure 7-14
Drive Positions
1
Two 5.25-inch external drive bays for optional drives (optical drives shown)
2
One 3.5-inch external drive bay for optional drive (media card reader shown)
3
Primary 3.5-inch internal hard drive bay
4
Secondary 3.5-inch internal hard drive bay for optional hard drive
62
Chapter 7
Removal and Replacement Procedures Microtower (MT) Chassis