Craftsman 22901 Instruction Manual - Page 3

17°in. Drill Press with Laser°Trac TM Motor Specifications: Motor type Continuous duty HP Maximum developedHP Amps Volts Phase Hertz R,P,M, induction 3/4 1=1/2 10/5 120/240 Single 60 1725 (no load) Product Specifications: Belt Type Pulley Type Number of Speeds Drill Speeds Spindle Taper Chuck Taper Chuck Type Chuck capacity Chuck to Table dimension Min, Chuck to Table dimension Max, Chuck to Base dimension Quill Diameter Quill Travel Quill Lock Poly=V Step Motor slide 16 215, 310, 340, 450, 490, 51 O, 600, 675, 735,750, 1200, 1380, 1500, 1850, 2035, 2720 #2 Morse Taper Jacobs 3 Keyless 1/32" =5/8" (1 =16mm) O_ 23-1/2" 43ol/2" 1 =7/8" (47mm) 4=7/8" Yes Handle Operation Motor Control Table Size Table Tilt Table Movement Table Material Depth Stop Depth Stop Type Depth Scab Column Diameter Base Work Area depth Depth of Throat Height Width Depth Weight Convenience: Light Laser 360 degree rotation Industrial push button with OFF paddle 14" wide x 14" depth Yes Rack and pinion Cast iron Yes Quick Set Yes 3-1/8" (80ram) 10=1/4" wide x 8=1/4" 8=1/2" 68=1/2" 12 =3/4" 28-1/2" 198 pounds Yes Yes To avoid electrical shock to yourself and damage to the drill press, use proper circuit protection, Do not expose to rain, or use in a damp environment, The drill press is factory wired for 120V, 60 Hz, operation, Connect to a 120V, 15 amp branch circuit and use a 15 amp time delay fuse or circuit breaker, The electrical circuit cannot have any wire size less than #14, To avoid shock or fire, replace power cord immediately if it is damaged in any way,