D-Link DSS-200G-28MP Product Manual - Page 9
DSS-200G-10MP, Front Panel
View all D-Link DSS-200G-28MP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
D-Link DSS-200G MP/MPP series Switch User Manual DSS-200G-10MP 8 x 10/100/1000 Mbps PoE ports + 2 x 100/1000 Mbps SFP surveillance switch Front Panel Figure 2-1 DSS-200G-10MP Front Panel Mode Button: By pressing the Mode button over 2 seconds, the Port LED (ports 1~8) will switch between the Link (refer to the below Link/Act/Speed LED) and PoE mode to indicate the PoE ports (refer to the below PoE LED) status or link speed: PoE/Link Mode LED Description Green The Port LED indicator is in Link/Act/Speed mode. Orange The Port LED indicator is in PoE mode. Reset: The Reset button has 3 modes: Reset Mode Description Reboot Press the reset button and hold it for 1~5 seconds to reboot the device. Reset to factory default Press the reset button and hold it for longer than 5 seconds (the port LEDs should all flash orange) to reset the device to its factory defaults, which will erase all configuration changes. Reset to loader mode Press the reset button and hold it for longer than 10 seconds to enter the loader mode (the port LEDs should all flash orange and then green), which allows you to upgrade the firmware. Alert LED: The Alert indicator is blinking red to indicate PoE malfunctioning events: PoE function startup failure, PoE function disabled due to thermal abnormality, PoE power denial, PoE power overload, and PoE power short circuit. The Alarm port on the back can also be connected to signify such events. Power LED: 4