Dell 1815dn Service Manual - Page 95
JAM 2, Check and Cause, Solution
UPC - 000061100008
View all Dell 1815dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Troubleshooting 7.1.3 JAM 1 • Description 1. Recording paper is jammed in front of or inside the fuser . 2. Recording paper is stuck in the discharge roller and in the fuser just after passing through the Actuator-Feed. Check and Cause L S U Solution Fuser CR Toner Cartridge 1. If the recording paper is jammed in 1. Replace the HVPS, it necessary. EXIT Sensor PR DR OPC SR front of or inside the fuser, cheek. PTL Feed MP Sensor TR Sensor FR (The feed sensor Nith diagnostic P IC Empty Sensor mode the exit.) K /R K /R 7.1.4 JAM 2 • Description 1. Recording paper is jammed in front of or inside the fuser . 2. Recording paper is stuck in the discharge roller and in the fuser just after passing through the Actuator-Feed. Check and Cause Solution L S U 1. If the paper is completely fed out of 1. Check if the exit sensor actuator is Fuser CR Toner the printer, but Jam 2 occurs defective. EXIT Sensor PR DR OPC SR : Exit sensor is defective. • Check if the actuator exit is deformed PTL Feed TR Sensor F • After the paper is completely dis - (Check if the lever part is deformed P IC Empty Sensor charged, actuator Exit should return to the original position to shut off the in shape). • Check whether burrs occur in the photo-sensor. Sometimes it takes assembly part of the actuator exit or longer than it should and does not not and if the actuator is smoothly return. operated. • Check if foreign matters and wire get caught in the actuator exit's operation. 2. If the paper is rolled in the Fuser Roller: • This occurs when a Guide claw is broken away or transformed. • It occurs when the Guide slaw spring is broken away or transformed. • It occurs when the Heat-Roller or Pressure-Roller is seriously contami nated with toner powder. 2. If the paper is stuck in the fuser : dis assemble the fuser and remove the jammed paper, and clean the surface of the pressure roller with dry gauze. 3. Paper is accordion jammed in fuser. 3. Remove the jammed paper after disassembling the fuser : Clean the surface of the pressure roller with dry gauze. • Remove the toner particles stained on the rib. • Check the assemblage and performance of the exit. 7-2 Service Manual