Dell 2135cn User Guide - Page 34

Fax Fwd Err Print On* Off Prints incoming faxes that failed to be forwarded when Fax Fwd Print is not selected. Does not print incoming faxes that failed to be forwarded when Fax Fwd Print is not selected. Prefix Dial On Off* Sets a prefix dial number. Does not set a prefix dial number. Prefix Dial Num 5byte Sets a prefix dial number of up to five digits. This number dials before any auto dial number is started. Off* Prints any excess at the bottom of a fax page without discarding it. Discard Size On Discards any excess at the bottom of the page. Auto Reduction Automatically reduces a fax page to fit it onto the appropriate sized paper. ECM On* Off Enables the ECM (Error Correction Mode). To use the ECM, the remote machines must also support the ECM. Disables the ECM. 2.4 4.8 Modem Speed 9.6 Allows you to adjust the fax modem speed when a fax transmission or reception error occurs. The default is 33.6. 11.4 33.6* Fax Activity Auto Print* No Auto Print Automatically prints a fax activity report after every 50 incoming and outgoing fax communications. Does not print a fax activity report automatically. Print Always Prints a transmission report after every fax transmission. Fax Transmit Print On Error* Prints a transmission report only when an error occurs. Print Disable Does not print a transmission report after a fax transmission. Print Always* Prints a transmission report after every fax transmission. Fax Broadcast Print On Error Prints a transmission report only when an error occurs. Print Disable Does not print a transmission report after a fax transmission to multiple destinations. Print Always Prints a protocol monitor report after every fax transmission. Fax Protocol Print On Error Prints the protocol monitor report only when an error occurs. Print Disable* Does not print the protocol monitor report. Country Selects the country where the printer is used. The default is United States. Apply New Settings After you complete the settings, press the Apply New Settings button to apply the changes. Restart printer to apply new settings Press the Restart printer to apply new settings button to apply the changes. Diagnosis The Diagnosis tab includes the Chart Print, Machine Check, Paper Wrinkle Check Mode, Environment Sensor Info, Developer Stir Mode, and Refresh Mode pages. NOTE: Values marked by an asterisk (*) are the factory default menu settings. Chart Print Purpose: To print various charts that can be used for the printer's diagnosis. Values: Outputs full halftone pages for yellow, magenta, cyan, and black. Also outputs pages to check the pitch. A total of five pages Pitch Configuration Chart are output. The chart is output to A4 or Letter size paper. Ghost Configuration Chart Outputs a chart to check for ghost printing. One page is output. The chart is output to A4 or Letter size paper. 4 Colors Configuration Chart Bands of yellow, magenta, cyan, and black are output with varying density. One page is output. The chart is output to A4 or Letter size paper. MQ Chart Outputs charts to check for the binding in A4 or Letter. Alignment Chart Outputs a chart to check for proper alignment of the print image on the paper. One page is output. The chart is output to A4 or Letter size paper. PHD Refresh Configuration Chart Outputs a chart to check the light fatigue of the PHD unit. One page is output. The chart is output to A4 or Letter size paper. Machine Check Purpose: