Dell Force10 E300 Installing and Maintaining the E300 System - Page 54

www.dell.com | support.dell.com Command interface management port config 100m interface management port config 10m interface management port config auto-negotiate interface management port config no auto-negotiate interface management port config full-duplex interface management port config half-duplex interface management port config show show interface management ethernet interface management ethernet ip address ip-address ip-addressmask Purpose (continued) • Use these commands to set the speed and duplex settings for the Management interface.The default setting is full-duplex and auto-negotiation. • Use the interface management port config show command to view the Management interface's physical settings. • Use the show interface management ethernet command to display the IP address and network mask of the management Ethernet port. • If the show command output does not display configured IP address information, use the interface management ethernet ip address ip-address ip-address-mask command to set the IP address of the Management Ethernet port for network (ftp/tftp) operating system boot. BOOT_USER # show interface management ethernet No IP address set for interface management ethernet 0/0! BOOT_USER # interface management ethernet ip address 1.2.3.4 255.255.0.0 Management ethernet 0/0 IP address: 1.2.3.4 255.255.0.0 boot zero {default | primary | secondary} reload Delete the boot configuration. Reload software. The autoboot program initializes and displays self-test results on the console screen. NOTE: Do not press break control sequence at any time during the boot/ reboot process. Doing so causes the boot process to terminate. Refer to the FTOS Command Line Interface Reference for BOOT_USER mode commands and commands for run-time modes. 54 | System Boot