Dell Force10 E300 Installing and Maintaining the E300 System - Page 7
About this Guide, Information Symbols and Warnings
View all Dell Force10 E300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
1 About this Guide This guide provides site preparation recommendations, step-by-step procedures for installing the Dell Force10 E300 chassis, as well as instructions to install the fan tray, power supplies, route processor modules (RPMs), switch fabric modules (SFMs), and line cards. This guide also includes instructions to remove and install field-replaceable parts. The E300 system is packaged with components necessary for optimal performance, including panel blanks for RPMs, SFMs, and line card slots, and, as required, power module blanks. Blanks are required in empty slots to ensure adequate system cooling, provide for personal safety, and for EMI containment during operation. After you have completed the hardware installation process and power up the system, refer to the FTOS™ Configuration Guide for preliminary software configuration information. FTOS™ Command Line Interface Reference provides details to configure Layer 2, Layer 3, and other network parameters. Information Symbols and Warnings The following graphic symbols are used in this document to bring attention to hazards that exist when handling the E300 and its components. Please read these alerts and heed their warnings and cautions. Table 1-1 describes symbols contained in this guide. Table 1-1. Information Symbols Symbol Warning Description Note This symbol informs you of important operational information. Caution Warning This symbol informs you that improper handling and installation could result in equipment damage or loss of data. This symbol signals information about hardware handling that could result in injury. WARNING: The installation of this equipment shall be performed by trained and qualified personnel only. Read this guide before installing and powering up this equipment. This equipment contains two power cords. Disconnect both power cords before servicing. WARNING: This equipment contains optical transceivers, which comply with the limits of Class 1 laser radiation. WARNING: Visible and invisible laser radiation may be emitted from the aperture of the optical transceiver ports when no cable is connected. Avoid exposure to laser radiation and do not stare into open apertures. About this Guide | 7