Dell Force10 E300 Installing and Maintaining the E300 System - Page 61

Module Power Requirements Module SFM E300 RPM E300 fan tray DC Power Entry Module AC Power Supply Unit 12-port Gigabit Ethernet line card with SFPs (LC-E ) 1-port 10 Gigabit Ethernet line card (LC-E) 12-port 100/1000 BASE T line card (LC-E) Catalog Number C-E-SFM3 LC-EF3-RPM CC-300-FAN CC-E300--PWR-DC CC-E300-1200W-AC Maximum Watts 55W 115W 85W 1400 W 1200 W W (BTU/hour) W (BTU/hour) W (BTU/hour) NOTE: Additional components may be available for your system, other than those included in the above table. Refer to www.force10networks.com for the latest information. Agency Compliance The E300 System is designed to comply with the following requirements. USA Federal Communications Commission (FCC) Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designated to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and used in accordance to the instructions, it may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case users will be required to take whatever measures necessary to correct the interference at their own expense. Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell Force10 is not responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications in the equipment. Unauthorized changes or modification could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Canadian Department of Communication Statement European Union EMC Directive Conformance Statement This product is in conformity with the protection requirements of EU Council Directive 2004/108/EC on the approximation of the laws of the Member States relating to electromagnetic compatibility. Force 10 Networks can not accept responsibility for any failure to satisfy the protection requirements resulting from a non-recommended modification of this product, including the fitting of non-Dell Force10 option cards. This product has been tested and found to comply with the limits for Class A Information Technology Equipment according to CISPR 22/ European Standard EN 55022. The limits for Class A equipment were derived for commercial and industrial environments to provide reasonable protection against interference with licensed communication equipment. WARNING: This is a Class A product. In a domestic environment, this device may cause radio interference, in which case, the user may be required to take adequate measures. System Specifications | 61