Dell OptiPlex Gs Service Manual (.pdf) - Page 22
Pin Assignments for the DC Power Connectors, DC Power Connector P1
View all Dell OptiPlex Gs manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Pin Assignments for the DC Power Connectors The power-supply output voltages can be measured at the back (wire side) of the connectors without disconnecting them. Figures 1-7 through 1-9 show the wire side of the connectors. -5 VDC (white) +5 VDC (red) common (black) +5 VDC (red) common (black) +5 VDC (red) common (black) TFSC 3 (brown) PSON# 1 (grey) +5 VDC (red) 11 12 13 14 15 16 17 18 19 20 P1 1 2 3 4 5 6 7 8 9 10 +5 VDC (red) common (black) common (black) +5 VDC (red) common (black) -12 VDC (blue) common (black) PWRGOOD 2 (orange) +12 VDC (yellow) +5 VFP (purple) 1 Pin 11 - PSON# should measure between +4 and +5 VDC except when the power button on the front panel is pressed, taking PSON# to its active-low state. 2 Pin 5 - PWRGOOD should measure between +4 and +5 VDC when the power supply is on and operating to indicate that all power-supply output voltages are within the ranges specified in Table 1-1. 3 Pin 19 - Thermal fan-speed control (TFSC) is a power-supply input signal used to control the power-supply fan speed. Figure 1-7. DC Power Connector P1 1234 P2, P3, P5, P6 +5 VDC (red) common (black) common (black) +12 VDC (yellow) P4 12 34 +12 VDC (yellow) common (black) common (black) +5 VDC (red) Figure 1-8. DC Power Connectors P2 (Midsize Computer), P3, P4, P5, and P6 (Midsize Computer) 1-10 Dell OptiPlex Gs and Gs+ Systems Service Manual