Dell PowerConnect FCS624S Configuration Guide - Page 1012

29 Displaying OSPF information PowerConnect#show ip ospf neighbor detail Port Address 9/1 20.2.0.2 Second-to-dead:39 10/1 20.3.0.2 Second-to-dead:36 1/1-1/8 23.5.0.1 Second-to-dead:33 2/1-2/2 23.2.0.1 Second-to-dead:33 Pri State 1 FULL/DR Neigh Address Neigh ID 20.2.0.1 2.2.2.2 Ev Op Cnt 6 2 0 1 FULL/BDR 20.3.0.1 3.3.3.3 5 2 0 1 FULL/DR 23.5.0.2 16.16.16.16 6 2 0 1 FULL/DR 23.2.0.2 15.15.15.15 6 2 0 Syntax: show ip ospf neighbor [router-id ] | [] | [detail] The router-id parameter displays only the neighbor entries for the specified router. The parameter displays only the entry in the specified index position in the neighbor table. For example, if you enter "1", only the first entry in the table is displayed. The detail parameter displays detailed information about the neighbor routers. These displays show the following information. TABLE 176 CLI display of OSPF neighbor information Field Description Port Address Pri The port through which the Layer 3 Switch is connected to the neighbor. The port on which an OSPF point-to-point link is configured. The IP address of this Layer 3 Switch interface with the neighbor. The OSPF priority of the neighbor: • For multi-access networks, the priority is used during election of the Designated Router (DR) and Backup designated Router (BDR). • For point-to-point links, this field shows one of the following values: • 1 = point-to-point link • 3 = point-to-point link with assigned subnet 970 PowerConnect B-Series FCX Configuration Guide 53-1002266-01